ADTRAN 6000 Series system manual Copyright 2005 ADTRAN, Inc

Section 7 MIBs TRACER 6000 Series Integrated System Manual

Table 3. Traps Supported by the TRACER 64x0 (Continued)

MIB	Trap	This trap indicates that....
TRACER6000.mib	adTRACERBPVoff	a change in the BiPolar Violation (BPV) state has
		occurred and the BPV alarm is inactive.
	adTRACERRAoff	a change in the Frame RA (Remote Alarm) state has
		occurred and the RA alarm is inactive.
	adTRACEROOFoff	a change in the Out Of Frame (OOF) state has
		occurred and the OOF alarm is inactive.
	adTRACERCVoff	a change in the Code Violation (CV) state has
		occurred and the CV alarm is inactive.
	adTRACERCRCoff	a change in the Cyclic Redundancy Check (CRC)
		state has occurred and the CRC alarm is inactive.
	adTRACERmfLOFoff	a change in the Loss of Multiframe (LOMF) state has
		occurred and the LOMF alarm is inactive.
	adTRACERmfLOSoff	a change in the Multiframe Loss of Signal (LOS)
		state has occurred and the Multiframe LOS alarm is
		inactive.
	adTRACERmfAISoff	a change in the Multiframe Alarm Indication Signal
		(AIS) state has occurred and the Multiframe AIS
		alarm is inactive.
	adTRACERmfRAoff	a change in the Multiframe Remote Alarm (RA) has
		occurred and the Multiframe RA alarm is inactive.
	adTRACERlineLoopbackOff	a change in the line loopback state has occurred and
		the line loopback is inactive.
	adTRACERlinkLoopbackOff	a change in the link loopback state has occurred and
		the link loopback is inactive.
	adTRACERLinkDown	the RF link is down.
	adTRACERLinkUp	the RF link is up.
	adTRACERRFCLinkDown*	the RFC link is down between the Indoor Unit (IDU)
		and Outdoor Unit (ODU). This trap only applies to
		TRACER split systems.
	adTRACERRFCLinkUp*	the RFC link is up between the IDU and ODU. This
		trap only applies to TRACER split systems.
	adTRACERRxLow	the receive level is within 10 dB of sensitivity and the
		RF Low alarm is active.
	adTRACERRxLevel	a change in receive level has occurred and the
		receive level is within normal range.
	adTRACERcurrThrsESon	the threshold for current Errored Seconds (ES) has
		been exceeded.
	adTRACERcurrThrsESoff	the threshold for current ES has not been exceeded.
	adTRACERcurrThrsSESon	the threshold for current Severely Errored Seconds
		(SES) has been exceeded.
	adTRACERcurrThrsSESoff	the threshold for current SES has not been
		exceeded.

* Not supported in TRACER 64x0 models. Listed trap only applies to TRACER split systems.

112 Copyright © 2005 ADTRAN, Inc. 612806420L1-1F