ADTRAN 6000 Series system manual DLP-2 Logging into the Tracer

DLP-2 Logging into the TRACER 64x0

Introduction

Once you are connected to the TRACER 64x0, you must log into the system to gain access to the management and provisioning functions. This DLP assumes you are connected to the TRACER 64x0 and provides specific steps for logging into the system.

Prerequisite Procedures

Complete DLP-1,Connecting a VT100 Terminal or PC to the CRAFT Port, on page 91.

To prevent electrical shock, do not install equipment in a wet location or during a lightning storm.

Electronic equipment can be damaged by static electrical discharge. Before handling it, put on an antistatic discharge wrist strap to prevent damage to electronic components. Place equipment in antistatic packing material when transporting or storing. When working on equipment, always place it on an approved antistatic mat that is electrically grounded.

see

After the IP parameters have been provisioned (see DLP-3,Setting IP Parameters for the TRACER 64x0, on page 95), you can also log in via Telnet.

612806420L1-1F Copyright © 2005 ADTRAN, Inc. 93