ADTRAN 6000 Series Craft Port DB-9, Reviewing the Tracer 64X0 Rear Panel Design, Craft Pinout

TRACER 6000 Series Integrated System Manual Section 3 Engineering Guidelines

CRAFT Port (DB-9)

The CRAFT connector provides a female DB-9 terminal connection (wired as a DCE interface), used for terminal access to the TRACER system. Table 4 shows the pinout. A null modem cable is necessary for connecting the CRAFT port to a modem for remote dial-up access. Table 5 shows the pinout for a null modem cable.

Table 4. CRAFT Pinout

Pin	Name	Source	Description
1	CD	TRACER	Carrier detect
2	RXDATA	TRACER	Received data (to attached equipment)
3	TXDATA	Attached Equipment	Transmit data (from attached equipment)
4	DTR	Attached Equipment	Data terminal ready (unused)
5	GND	Common	Signal ground
6	DSR	TRACER	Data set ready
7	RTS	Attached Equipment	Request to send (unused)
8	CTS	TRACER	Clear to send
9	RI	TRACER	Ring indicator (unused)

Table 5. Null-Modem Pinout

	Modem		TRACER 64x0
	Pin		Pin
1	(CD)	Unconnected
2	(RXD)	3	(TXD)
3	(TXD)	2	(RXD)
4	(DTR)	6	(DSR)
5	(GND)	5	(GND)
6	(DSR)	4	(DTR)
7	(RTS)	8	(CTS)
8	(CTS)	7	(RTS)
9	(RI)	Unconnected

4.REVIEWING THE TRACER 64X0 REAR PANEL DESIGN

Figure 3 on page 34 identifies the features of the TRACER rear panel, and Table 6 on page 34 provides a brief description of each interface.

612806420L1-1F Copyright © 2005 ADTRAN, Inc. 33