ADTRAN 6000 Series system manual DLP-4 Verifying Communications Over an IP LAN

DLP-4 Verifying Communications Over an IP LAN

Introduction

When the 10/100BaseT/TX MGMT port is connected to a local area network (LAN), test steps must be performed on the TRACER 64x0 to ensure that the unit is communicating properly over the network. This procedure outlines those steps.

Prerequisite Procedures

Before beginning this procedure, the unit should be physically connected to the LAN and the provisioning tasks detailed in DLP-3,Setting IP Parameters for the TRACER 64x0, on page 95 should be complete.

Tools and Materials Required

•Access to a PC or other computer connected to the LAN

To prevent electrical shock, do not install equipment in a wet location or during a lightning storm.

Electronic equipment can be damaged by static electrical discharge. Before handling it, put on an antistatic discharge wrist strap to prevent damage to electronic components. Place equipment in antistatic packing material when transporting or storing. When working on equipment, always place it on an approved antistatic mat that is electrically grounded.

612806420L1-1F 99