ADTRAN 6000 Series system manual Datapath Provisioning Total Active Channels

TRACER 6000 Series Integrated System Manual Section 5 User Interface Guide

>DATAPATH PROVISIONING

Figure 12 shows the Datapath Provisioning menu page, which displays the active network interfaces for the installed modules (from both the local and remote TRACER 64x0 units).

Figure 12. Datapath Provisioning

>DATAPATH PROVISIONING > TOTAL ACTIVE CHANNELS

Defines the total number of channels active on the installed modules. Specify 2, 4, or 8 total active channels. After defining the total number of active channels, specify the actual active channels using the CHANNEL

SELECTION menu.

>DATAPATH PROVISIONING > MODULE 1/MODULE 2 CHANNELS

(Read Only) Displays the total number of active channels on the installed module.

The number of active channels and the channel configuration on both the local and remote systems must match for the RF link to function properly. A discrepancy between the systems can result in unpredictable operation.

>DATAPATH PROVISIONING > CHANNEL SELECTION

Defines the active channels (A, B, C, D) on each installed T1 module or the bandwidth dedicated to the Quad Ethernet Switch module (in 2 Mbps steps). To activate a channel, press <Enter> and use the spacebar or arrow keys to cycle through the available channel combinations until the desired combination displays. Press <Enter> again to make the channel combination change. If the specified channel selection is not valid, the TRACER 64x0 automatically corrects the configuration and populates the field with a valid selection.

The number of active channels and the channel configuration on both the local and remote systems must match for the RF link to function properly. A discrepancy between the systems can result in unpredictable operation.

612806420L1-1F Copyright © 2005 ADTRAN, Inc. 69