ADTRAN 624, 612, 616, 606, 604 Interfaces Network T1, Interfaces T1 Config Timing Mode

Total Access 600 Series System Manual Section 4 User Interface Guide

INTERFACES

Use the INTERFACES menu to view and configure parameters for the various system interfaces (T1, SHDSL, SDSL, ADSL, Ethernet (ETH), V.35, FXS, FXO, and DSX-1). Figure 6 displays the interfaces menu for an

SDSL IAD.

Figure 6. Interfaces Menus

INTERFACES (NETWORK T1)

View the network T1 interface status and configure T1 parameters from this menu. These menus are only applicable to T1 Total Access 600 Series systems.

INTERFACES (T1) > CONFIG

Configure the various T1 parameters and enable/disable loopbacks from this menu.

INTERFACES (T1) > CONFIG > TIMING MODE

Choices are NETWORK, INTERNAL, and DSX-1. Select NETWORK when the unit will receive timing from the network. Select INTERNAL when the unit will generate the timing. Select DSX-1when the system needs to take timing from the T1 connected to the DSX-1interface. (The DSX-1option is only valid for Total Access 600 Series systems that have the optional DSX-1interface.) Default is NETWORK.

INTERFACES (T1) > CONFIG > FORMAT

This sets the frame format for the T1 interface. The setting must match the frame format of the circuit to which the interface is connected. Choices are ESF or SF (D4). Extended Superframe (ESF) provides a non-disruptive means of full-time monitoring on the facility datalink (FDL). Default is ESF.

61200624L1-1B © 2004 ADTRAN, Inc. 71