ADTRAN 616, 612 DLP-3 Setting IP Parameters, IP Address Subnet Mask User guest Password password

DLP-3 Setting IP Parameters

Introduction

The Total Access 6XX comes pre-programmed for default Telnet access. The following IP parameters apply:

•IP Address: 10.0.0.1

•Subnet Mask: 255.255.255.0

• User: guest

• Password: password

For security purposes, change the default Telnet password during the initial unit configuration. (Refer to System Config > Management > Telnet Access > User List on page 53 for more details.)

If the Total Access 6XX is connected to an IP network for Telnet, TFTP, or SNMP management, there are several IP parameters which must be set for the unit to communicate with the network. These parameters are described in this DLP along with the procedures for setting them.

Please see your Network Administrator for the proper assignment of the following

parameters: IP ADDRESS, SUBNET MASK, and DEFAULT GATEWAY.

Prerequisite Procedures

This procedure assumes that the Total Access 6XX unit is connected to an IP network and is powered up.

Tools and Materials Required

•VT100 compatible terminal or computer with terminal emulation software

•Appropriate cable to connect terminal to the Total Access 6XX (customer-provided).

•DB-9 female to RJ-48 female adapter (ADTRAN proprietary) for connecting to the CRAFT port on the rear of the unit (see CRAFT Port on page 31).

To prevent electrical shock, do not install equipment in a wet location or during a lightning storm.

Electronic equipment can be damaged by static electrical discharge. Before handling modules, put on an antistatic discharge wrist strap to prevent damage to electronic components. Place equipment in antistatic packing material when transporting or storing. When working on equipment, always place it on an approved antistatic mat that is electrically grounded.

61200624L1-1B © 2004 ADTRAN, Inc. 189