ADTRAN 612, 616, 606, 624 Configuring the Layer 2 Protocol, Ethernet Interface Setup Instructions

Total Access 600 Series System Manual Section 4 User Interface Guide

Ethernet Interface Setup Instructions

Most applications should not require a manual setup for the Ethernet interface. By default, the Ethernet interface is configured to auto-detect the data rate (as either 10 or 100 Mbps). The following steps disable the auto-negotiation parameter and manually configure the interface.

Step Action

1From the main menu, select INTERFACES.

2Highlight the CONFIG menu for the ETH interface and press <ENTER>.

3Use the right arrow to select AUTONEGOTIATION and press <ENTER>. Use the down arrow to choose OFF.

4Select the DATA RATE field and specify either 10BASET or 100BASET.

5Select the DUPLEX TYPE field and specify either HALF DUPLEX or FULL DUPLEX.

2.Configuring the Layer 2 Protocol

For more details on the configuration parameters discussed in this section, refer to the following pages:

Layer 2 Frame Relay Protocol menus beginning on page 93

Layer 2 PPP Protocol menus beginning on page 91

Layer 2 Ethernet menus beginning on page 116

Layer 2 Protocol (FRE) Configuration – T1 Interface

Step Action

1From the main menu, select L2 PROTOCOL and press <ENTER>.

2Use the arrow keys to select the PROTOCOL field for the T1 interface. Press <ENTER>. Select FRE from the list of available protocols.

3Highlight the CONFIG menu for the T1 interface and press <ENTER>.

4Set the MAINTENANCE PROTOCOL to ANNEX D (ANSI), ANNEX A (q933a), LMI, OR

STATIC (no sig).

The MAINTENANCE PROTOCOL should be set based on the Frame Relay switch.

Down arrow and press <ENTER> on DLCI MAPPING. Press the right arrow key to

5create an entry. To create additional entries, highlight the NUM field and press the <I> key. To delete an entry, highlight the NUM field for the entry to delete and press the <D> key.

6Set ACTIVE to YES.

61200624L1-1B © 2004 ADTRAN, Inc. 153