ADTRAN 624, 612, 616, 606, 604 system manual DLP-17 Configuring Dual T1 Maps, Introduction

DLP-17 Configuring Dual T1 Maps

Introduction

Total Access 6XX T1 TDM systems with the optional DSX-1 interface have a DUAL T1 MAP feature that allows two network T1 connections for the termination of data and voice applications. The primary network T1 MAP can be configured for internal router usage (FT1/24 DS0s maximum) or any other interfaces. The DSX MAP can be used for FXS/FXO interfaces. There are several steps that must be followed in order for the Dual T1 Map to be configured successfully. These steps are described in this DLP.

Prerequisite Procedures

This procedure assumes that the user has access to the Total Access 6XX system menus and has completed the T1 and DSX-1 interface configuration (as detailed in Appendix D. Configuring the Unit for DSX-1 Applications on page 166).

Refer to DLP-1, Connecting a VT100 Terminal or PC to the CRAFT Port, for details on making a terminal connection to the Total Access 6XX.

To prevent electrical shock, do not install equipment in a wet location or during a lightning storm.

Electronic equipment can be damaged by static electrical discharge. Before handling modules, put on an antistatic discharge wrist strap to prevent damage to electronic components. Place equipment in antistatic packing material when transporting or storing. When working on equipment, always place it on an approved antistatic mat that is electrically grounded.

61200624L1-1B © 2004 ADTRAN, Inc. 231