ADTRAN 606, 612, 616 Setting the Router Options, Layer 2 Protocol Configuration Ethernet Interface

Total Access 600 Series System Manual Section 4 User Interface Guide

Layer 2 Protocol Configuration – Ethernet Interface

Set mode to ROUTE IP. Using this menu you also have the option to route only

3IP packets and bridge all other data packets (ROUTE IP/BRIDGE OTHER) or bridge all data packets on this connection (BRIDGE ALL). Refer to L2 Protocol (ALL–ETH–802.3) > Config > Mode on page 116 for more details.

4Left arrow back to the main menu to save the changes.

3.Setting the Router Options

For more details on the configuration parameters discussed in this section, refer to the following pages:

Router Ethernet Interface Configuration menus beginning on page 119

Router Network Interface Configuration menus beginning on page 122

Router Default Gateway menus beginning on page 128

	Router Options – Ethernet Interface
Step	Action
1	From the main menu, select ROUTER and press <ENTER>.
2	Use the right arrow key to highlight CONFIG and press <ENTER>.
3	Select INTERFACES and press <ENTER>. Use the right arrow key to highlight the
	SETUP field for the ETH (Ethernet) interface and press <ENTER>.
4	Highlight the PRIMARY IP field and press <ENTER>.
5	Set the IP ADDRESS of the Ethernet port.
6	Set the SUBNET MASK for the Ethernet port.
	By default, RIP is disabled on the Ethernet interface. If RIP needs to be
	enabled, highlight the RIP field and press <ENTER>. Set the appropriate
7	VERSION, RIP METHOD, DIRECTION, and V2 SECRET (where applicable) to
	configure RIP on the interface. For more details, refer to Router > Config >
	Interfaces (ETH) > Sub-Interfaceon page 120.
8	Press the left arrow key to return to the Ethernet sub-interface menu (displays
	PRIMARY IP and SECONDARY IP).
	If your application requires additional secondary IP address, highlight the
	SECONDARY IP field and press <ENTER>. The Total Access 6XX supports up to
9	5 additional LAN segments. Enter each additional secondary IP address and
	corresponding subnet mask. To add a new IP address entry, highlight the NUM
	field and press the <I> key. To delete an existing entry, highlight the NUM field
	for the entry to delete and press the <D> key.
10	Left arrow back to the main menu to save the changes.

61200624L1-1B © 2004 ADTRAN, Inc. 155