ADTRAN 624, 612, 616, 606, 604 system manual Layer 2 Protocol ATM Configuration T1 Interface

Section 4 User Interface Guide Total Access 600 Series System Manual

.2. Configuring the Layer 2 Protocol

For more details on the configuration parameters discussed in this section, refer to the following pages: Layer 2 ATM Network Interface Protocol menus beginning on page 101

	Layer 2 Protocol (ATM) Configuration – T1 Interface
Step	Action
1	From the main menu, select L2 PROTOCOL and press <ENTER>.
2	Use the arrow keys to select the PROTOCOL field for the T1 interface. Press
	<ENTER>. Select ATM from the list of available protocols.
3	Use the arrow keys to select the CONFIG menu for the T1 interface and press
	<ENTER>.
4	Highlight the ATM CONFIG menu for the T1 interface and press <ENTER>.
5	Enter the IDLE CELLS format for your network.
6	Set DATA SCRAMBLING appropriately for your network.
7	Back all the way out to one level to the PVC CONFIG menu, and press <ENTER>.
	Enter the VPI and VCI values for communicating with that Gateway. Select
	ROUTER under the CONNECTION field.
	Select the SETUP menu and configure the virtual circuit for IP or PPP operation.
8	(Our example selects IP.) Refer to L2 Protocol (ATM–NET–ATM) > Config >
	PVC Config > Setup (Router) on page 103 for more details.
	Set mode to ROUTE IP. Using this menu you also have the option to route only
	IP packets and bridge all other data packets (ROUTE IP/BRIDGE OTHER) or
9	bridge all data packets on this connection (BRIDGE ALL). Refer to L2 Protocol
	(ATM–NET–ATM) > Config > PVC Config > Setup (Router) on page 103 for
	more details.
10	Left arrow back to the main menu to save the changes.

176 © 2004 ADTRAN, Inc. 61200624L1-1B