ADTRAN 604, 612, 616, 606, 624 system manual Layer 2 Protocol Configuration T1 Interface

Section 4 User Interface Guide Total Access 600 Series System Manual

FXS Interface Setup Instructions (Continued)

11Press <ENTER> on the TANDEM [+] option to view the TANDEM options if the port mode is set to TANDEM (E&M).

12Set the CONVERSION MODE of the port to either LOOP START or GROUND

START.

13Set the SUPERVISION of the port to either IMMEDIATE or WINK.

Be sure to set the TANDEM options for each port set to TANDEM E&M.

2. Configuring the Layer 2 Protocol

For more details on the configuration parameters discussed in this section, refer to the following pages: Layer 2 ATM Network T1 menus beginning on page 101

	Layer 2 Protocol Configuration – T1 Interface
Step	Action
1	From the main menu, select L2 PROTOCOL and press <ENTER>.
2	Use the arrow keys to select the PROTOCOL field for the T1 interface. Press
	<ENTER>. Select ATM from the list of available protocols.
3	Use the arrow keys to select the CONFIG menu for the T1 interface and press
	<ENTER>.
4	Highlight the ATM CONFIG menu for the T1 interface and press <ENTER>.
5	Enter the IDLE CELLS format for your network.
6	Set DATA SCRAMBLING appropriately for your network.
	Back all the way out to one level to the PVC CONFIG menu, and press <ENTER>.
7	Enter the VPI and VCI values for communicating with that Gateway. (From this
	menu, the appropriate Voice information for working with the Voice Gateway is
	entered by selecting VOICE under the CONNECTION field.)

172 © 2004 ADTRAN, Inc. 61200624L1-1B