ADTRAN 606, 612, 616, 624, 604 system manual DLP-5 Connecting to the Unit Using Telnet, Introduction

DLP-5 Connecting to the Unit Using Telnet

Introduction

The Total Access 6XX comes pre-programmed for default Telnet access. The following IP parameters apply:

•IP Address: 10.0.0.1

•Subnet Mask: 255.255.255.0

• User: guest

• Password: password

For security purposes, change the default Telnet password during the initial unit configuration. (Refer to System Config > Management > Telnet Access > User List on page 53 for more details.)

If the Total Access 6XX is part of a management cluster connected to the local network, you may use a PC connected to the network to Telnet into the unit. This procedure details the steps which must be performed to Telnet into the unit.

Prerequisite Procedures

Complete DLP-3,Setting IP Parameters and DLP-4,Verifying Communications Over an IP LAN.

Tools and Materials Required

•Access to a PC or other computer connected to the LAN.

To prevent electrical shock, do not install equipment in a wet location or during a lightning storm.

Electronic equipment can be damaged by static electrical discharge. Before handling modules, put on an antistatic discharge wrist strap to prevent damage to electronic components. Place equipment in antistatic packing material when transporting or storing. When working on equipment, always place it on an approved antistatic mat that is electrically grounded.

61200624L1-1B © 2004 ADTRAN, Inc. 195