ADTRAN 604, 612, 616, 606, 624 system manual DLP-2 Logging in to the System

DLP-2 Logging in to the System

Introduction

Once connected to the Total Access 6XX, you must login to the system to gain access to the management and provisioning functions. This DLP assumes you are connected to the Total Access 6XX and provides specific steps for logging into the system.

Prerequisite Procedures

Complete DLP-1,Connecting a VT100 Terminal or PC to the CRAFT Port.

To prevent electrical shock, do not install equipment in a wet location or during a lightning storm.

Electronic equipment can be damaged by static electrical discharge. Before handling modules, put on an antistatic discharge wrist strap to prevent damage to electronic components. Place equipment in antistatic packing material when transporting or storing. When working on equipment, always place it on an approved antistatic mat that is electrically grounded.

After the IP parameters have been provisioned (see DLP-3, Setting IP Parameters), you can also log in via Telnet.

61200624L1-1B © 2004 ADTRAN, Inc. 187