ADTRAN 612, 616, 606, 624, 604 system manual Router Options T1 Interface L2 Protocol = ATM

Section 4 User Interface Guide Total Access 600 Series System Manual

Router Options – T1 Interface (L2 Protocol = ATM) (Continued)

Select INTERFACES and press <ENTER>. Use the right arrow key to highlight the

3SETUP field for the T1 interface and press <ENTER>. Each virtual circuit on the T1 interface defined in the PVC CONFIG has a separate listing in the ROUTER

INTERFACES table.

4Set ACTIVE to YES to activate the virtual circuit.

5Enter the appropriate VPI and VCI values.

6Select the desired ADDRESS MODE. Refer to Address Mode on page 122 for more details.

7Enter the Total Access 6XX LOCAL IP ADDRESS and corresponding IP NETMASK for the selected virtual circuit.

8Enter the IP address for the next hop router in the FAR-ENDIP ADDRESS field.

9For NAT configuration, refer to Appendix C. RFC1483 Quick Start (IP Routing with NAT) on page 179.

10Left arrow back to the main menu to save the changes.

Router Options – Setting the Default Gateway

Step Action

1From the main menu, select ROUTER and press <ENTER>.

2Use the right arrow key to highlight CONFIG and press <ENTER>.

3Select ROUTES and press <ENTER>. Set the DEFAULT GATEWAY field to the appropriate IP address.

4Left arrow back to the main menu to save the changes.

178 © 2004 ADTRAN, Inc. 61200624L1-1B