ADTRAN 606, 612, 616, 624, 604 system manual Perform the steps below in the order listed, Enter

Section 5 DLP-6 Total Access 600 Series System Manual

Perform the steps below in the order listed.

1.Connect to the Total Access 6XX using either the 10/100BASET or CRAFT interface.

If you are not already connected to the unit’s CRAFT interface (either with a VT100 compatible terminal or with a PC running VT100 emulation software), follow the procedure in DLP-1,Connecting a VT100 Terminal or PC to the CRAFT Port).

Alternately, if the unit is part of a management cluster connected to the local network, you may use a PC connected to the network to Telnet into the unit. Use the procedures in DLP-3,Setting IP Parameters, and DLP-5,Connecting to the Unit Using Telnet, to connect to the 10/100BASET interface.

2.Log in to the unit using the read-write password (see DLP-2,Logging in to the System, for more details).

Password security levels only apply to users connecting to the Total Access 6XX system through Telnet access. All connections made through the CRAFT interface ALWAYS have maximum security rights.

3.Go to the SYSTEM CONFIG/MANAGEMENT/TELNET ACCESS menu, select the USER LIST menu, and press

<Enter>.

4.Add a new user profile and password by selecting the first column (0) and pressing <I> (for insert).

5.Give the new user profile a name by selecting the NAME field, pressing <Enter>, and typing the user defined name. All new Telnet entries have a INACTIVE as the NAME. Enter a specific username to use for Telnet login. Each Telnet entry in the list must have a unique assigned name because duplicate names are not allowed. Refer to System Config > Management > Telnet Access > User List on page 53 for more details.

6.Personalize the password for the appropriate level by selecting the PASSWORD field, pressing <Enter>, then typing the appropriate password. You will have to type the new password again to confirm it.

Passwords for the Total Access 6XX system are case sensitive. There is no default password for a new user (i.e., you can configure a user as blank with no password). The current password displays as a series of asterisks (********).

7.Select the IDLE TIME field and press <Enter>. This field defines the amount of time in minutes the session may be idle before the user is logged off. The range is 1-255and the default value is 10.

200 © 2004 ADTRAN, Inc. 61200624L1-1B