Total Access 600 Series System Manual

Section 4 User Interface Guide

 

 

L2 PROTOCOL (TDM–T1–FRE) > CONFIG > DLCI MAPPING INTERFACE

Shows the user the physical and logical port associated with each DLCI. This is a read-only field.

L2 PROTOCOL (TDM–T1–FRE) > CONFIG > DLCI MAPPING > DLCI

This DLCI (Data Link Connection Identifier) number identifies the virtual circuit being configured.

L2 PROTOCOL (TDM–T1–FRE) > CONFIG > DLCI MAPPING > MODE

The mode identifies how the data will be forwarded. The choices are:

ROUTE IP (def)

All IP data for this DLCI will be routed.

BRIDGE ALL

All data for this DLCI will be bridged.

ROUTE UIP/BRIDGE OTHER All IP data will be routed. All other data will be bridged.

L2 PROTOCOL (TDM–T1–FRE) > CONFIG > DLCI MAPPING > BECN TIMEOUT (MSEC)

This value is expressed in milliseconds and represents the amount of time the unit will stop transmitting over a PVC which received a packet with the BECN bit set. Range is 50-5000msec; the default is

50MILLLISECONDS.

L2 PROTOCOL (TDM–T1–FRE) > STATUS

View the L2 protocol status for the T1 interface using the Frame Relay protocol.

L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT

View the Frame Relay statistics on the WAN port.

L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT > PORT INDEX

Integer used for identifying DLCIs on an interface. A single DLCI will always be port index 0. Subsequent DLCIs will have incrementing port indices.

L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT > SIGNAL STATE

Displays “up” when the unit is communicating with the Frame Relay switch; otherwise displays “down”.

L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT > TX FRAMES

Total frames transmitted out the WAN port.

L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT > RX FRAMES

Total frames received from the WAN port.

L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT > TX BYTES

Total bytes transmitted out the WAN port.

L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT > RX BYTES

Total bytes received on the WAN port.

61200624L1-1B

© 2004 ADTRAN, Inc.

95

Page 97
Image 97
ADTRAN 606, 612, 616 L2 Protocol TDM-T1-FRE Config Dlci Mapping Interface, L2 Protocol TDM-T1-FRE Config Dlci Mapping Dlci