ADTRAN 612, 616, 606, 624, 604 system manual L2 Protocol ATM-NET-ATM Config PVC Config VCI

Total Access 600 Series System Manual Section 4 User Interface Guide

L2 PROTOCOL (ATM–NET–ATM) > CONFIG > PVC CONFIG > VCI

This is the ATM Virtual Channel Identifier that serves as an address for the virtual channel cell transmissions between two devices. The range is 0-65355. The default setting is 38.

L2 PROTOCOL (ATM–NET–ATM) > CONFIG > PVC CONFIG > CONNECTION

Select the physical and logical method of data transfer over the virtual path. There are three valid connection entries: ROUTER, V35, and VOICE. Select ROUTER to connect traffic from this PVC to the Total Access 600 Series integral IP router. Select V35 to connect traffic from this PVC to a V.35 interface on the system. Select VOICE to connect traffic from this PVC to a voice connection (on a DSX-1 or FXS interface).

L2 PROTOCOL (ATM–NET–ATM) > CONFIG > PVC CONFIG > SETUP (ROUTER)

Use these menus to configure the router parameters for this logical connection from the router to the T1 interface. These menus are only applicable when the CONNECTION parameter is set to ROUTER.

CONNECTION (ROUTER) > SETUP > PROTOCOL

Selects the data-link protocol for the PVC connection between the T1 interface and the router. The choices are: IP (def) and PPP.

CONNECTION (ROUTER) > SETUP > MODE

Identifies how the data will be transferred through the Total Access 600 Series system. The following choices are available:

ROUTE IP (def) – All IP data for this PVC is routed through the Total Access 600 Series integral router.

BRIDGE ALL – All data for this PVC is bridged through the Total Access 600 Series system. ROUTE IP/BRIDGE OTHER – All IP data for this PVC is routed through the Total Access 600 Series integral router and all other data is bridged through the system.

CONNECTION (ROUTER) > SETUP > PPP SETUP

Provides PPP configuration parameters for the PVC. These menus are only visible when the MODE is set to PPP.

AUTHENTICATION

Contains the required parameters for PPP peer authentication and for being authenticated by the PPP peer. Authentication is applied between the unit and the PPP peer as described in the submenus.

61200624L1-1B © 2004 ADTRAN, Inc. 103