ADTRAN 606, 612, 616, 624, 604 system manual L2 Protocol ATM-NET-ATM Config PVC Config Setup

Total Access 600 Series System Manual Section 4 User Interface Guide

MAX CONFIG

This value is the number of unanswered configuration-requests that should be transmitted before resetting PPP negotiations. the possible values are 5, 10, 15, and 20 (def).

MAX TIMER (SEC)

This value is the number of seconds to wait between unanswered configuration-requests. The possible values are 1 SEC, 2 SECS, 3 SECS (DEF),

5SECS, and 10 SECS.

MAX FAILURE

Due to the nature of PPP, configuration option may not be agreed upon between two PPP peers. This value is the number of configuration-naks that should occur before an option is configuration-rejected. The possible values are 5 (DEF), 10, 15, and 20.

FORCE PEER IP ADDRESS

This option forces the PPP to negotiate the IP address entered instead of allowing another address to be assigned by the remote end. The default is NO.

KEEPALIVE PERIOD

This option allows the user to generate PPP keepalive packets that can be sent every 1 minute, 2 minutes, or every 5 minutes. A value of 0 (OFF) disables the PPP keepalive packet generating feature. The default is 0 (OFF).

PPPENCAPSULATION

This option allows the user to set the encapsulation modes for PPP over ATM. LLC has an encapsulation header in the AAL5 frame indicating it is encapsulating PPP. VC-Mux does not have a header, and is therefor dedicated to using PPP. The choices are LLC or VC-MUX. The default is VC-MUX.

SEND IDENTIFICATION

When enabled, this option enables the Total Access 600 Series to send the system identification code in response to a configure acknowledgement from the peer equipment. For most peer routers this option should be configured as YES. If set to NO, the Total Access 600 Series will accommodate peer routers that do not correctly respond to the identification code.

L2 PROTOCOL (ATM–NET–ATM) > CONFIG > PVC CONFIG > SETUP (V35)

Use these menus to configure the V35 parameters for this logical connection from the T1 interface to the V.35 port. These menus are only applicable when the CONNECTION parameter is set to V35.

61200624L1-1B © 2004 ADTRAN, Inc. 105