ADTRAN 612, 616, 606, 624, 604 system manual Use this menu to enter static routes to other networks

Section 4 User Interface Guide Total Access 600 Series System Manual

ROUTER > CONFIG > ROUTES

Configures the default gateway and static routes from this menu.

ROUTER > CONFIG > ROUTES > DEFAULT GATEWAY

The default gateway is used by the unit to send IP packets whose destination addresses are not found in the route table (otherwise known as the gateway of last resort). This is a default gateway for the entire unit, not just for the Ethernet port. Default is 0.0.0.0., which configures the Total Access 6XX to use the WAN port as the default gateway.

ROUTER > CONFIG > ROUTES > STATIC ROUTES

Use this menu to enter static routes to other networks.

NUM

Displays the index number in the static route table.

ACTIVE

Adds this static route entry to the IP routing table when set to YES and removes it (if it was previously added) if set to NO. Default is NO.

IP ADDRESS

The IP address of the host or network address of the device being routed to. Default is 0.0.0.0.

SUBNET MASK

Determines the bits in the previous IP address that are used. If this is to be a host route, it must be set to all ones (255.255.255.255). Default is 0.0.0.0.

GATEWAY

The IP address of the router to receive the forwarded IP packet. Default is 0.0.0.0.

HOPS

The number of router hops required to get to the network or host. Maximum distance is 16 hops. Default is 1.

PRIVATE

When set to NO, the unit will advertise this static route using RIP. Setting to YES means that the route is kept private. Default is NO.

ROUTER > CONFIG > DHCP SERVER

Use this menu to set up the DHCP server.

128 © 2004 ADTRAN, Inc. 61200624L1-1B