L2 Protocol TDM-T1-AUTO Status | ADTRAN 616, 612, 606, 624, 604

Total Access 600 Series System Manual	Section 4 User Interface Guide

L2 PROTOCOL (TDM FIRMWARE) – T1 INTERFACE > AUTO PROTOCOL

View the status of the T1 interface with the L2 PROTOCOL set to AUTO (using Auto-config feature).

View the status of the auto detect function and traffic flow for the T1 interface with an L2 PROTOCOL set to

AUTO.

This field represents the state of the auto detect/configuration function. The possible state are:

OFF	The T1 interface is down, so the auto-detect/configuration process is
	currently idle.
DETECTING L2	The T1 interface is up and waiting for the first control/signaling packet.
PROTOCOL
CONFIRMING FR	The T1 interface is up and one FR signaling packet has been received
CONFIRMED FR	The T1 interface is up and two FR signaling packets have been received.
	It takes two consecutive control/signaling packets of the same type to
	confirm the detected protocol.
CONFIRMING PPP	The T1 interface is up and one PPP control packet has been received.
CONFIRMED PPP	The T1 interface is up and two PPP control packets have been received. It
	takes two consecutive control/signaling packets of the same type to
	confirm the detected protocol.

Number of packets transmitted out of the WAN port.

Number of packets received on WAN port.

L2 PROTOCOL (TDM–T1–AUTO) > STATUS > TX BYTES

Number of bytes transmitted out of the WAN port.

L2 PROTOCOL (TDM–T1–AUTO) > STATUS > RX BYTES

Number of bytes received out of the WAN port.

L2 PROTOCOL (TDM–T1–AUTO) > STATUS > CLEAR STATS

Clears all the gathered statistics for this interface and returns the counters to 0.

61200624L1-1B