ADTRAN 616, 612, 606, 624, 604 Appendix B. RFC1483 Quick Start IP Routing, Application Diagram

Section 4 User Interface Guide Total Access 600 Series System Manual

Appendix B. RFC1483 Quick Start (IP Routing)

The Total Access 6XX allows for complete integration of voice and data delivery from one compact platform (see Figure 10). Once you have completed the voice turn up procedure from the previous example, adding data to the circuit requires some additional setup.

Figure 10. Application Diagram

To configure a Total Access 6XX for IP routing, you need to know the VPI and VCI values for the data circuit on your network. You also need the IP address of the next hop router in the circuit.

Perform the following steps in order to configure the application.

Initial Setup

It is best to configure Total Access 6XX ATM applications by following the order of the top-level menus. For example, first configure the system parameters using the SYSTEM INFO and SYSTEM CONFIG menus. Next, configure the Layer 1 parameters using the INTERFACES menu. Once the Layer 1 information is configured, proceed to the Layer 2 setup using the L2 PROTOCOL menus. Follow the Layer 2 setup with the data “routing” menus (either BRIDGE or ROUTER). Finally, establish packet forwarding and blocking using the SECURITY menus.

The following example provides step by step instructions for configuring the Total Access 6XX T1 ATM system (INTERFACES and L2 PROTOCOL) for a standard routing application. System Info and System Config parameters should be set according to your system need. Refer to System Info on page 49 and System Config on page 51 for more details.

1. Setting up the Interfaces

For more details on the configuration parameters discussed in this section, refer to the following pages:

Network T1 menus beginning on page 71

Ethernet menus beginning on page 81

174 © 2004 ADTRAN, Inc. 61200624L1-1B