ADTRAN 624, 612, 616, 606, 604 system manual System Config Management Craft Port

Total Access 600 Series System Manual Section 4 User Interface Guide

SYSTEM CONFIG

Set up the unit’s operational configuration from the SYSTEM CONFIG menu. Figure 4 shows the items included in this menu.

Figure 4. System Config Menu

SYSTEM CONFIG > MANAGEMENT

Set up the CRAFT port, TELNET ACCESS, SNMP MANAGEMENT, and FDL MANAGEMENT from this menu.

SYSTEM CONFIG > MANAGEMENT > CRAFT PORT

Set up the CRAFT port parameters from this menu. The unit’s VT100 CRAFT port can be accessed via an RJ-48 connector located on the rear of the unit.

SYSTEM CONFIG > MANAGEMENT > CRAFT PORT > PASSWORD PROTECT

When PASSWORD PROTECT is set to NO, the CRAFT port is not password protected. When set to YES (def), the unit will prompt for a password upon startup.

SYSTEM CONFIG > MANAGEMENT > CRAFT PORT > PASSWORD

Enter the user-defined password (up to 30 alphanumeric characters including spaces and special characters) to protect the CRAFT port. By default, no password is entered. Table 2 on page 52 provides instructions for changing the password.

Connecting directly to the CRAFT port provides full access to all menus. Enable the password on the CRAFT port to protect against unauthorized access.

61200624L1-1B © 2004 ADTRAN, Inc. 51