ADTRAN 612, 616, 606, 624, 604 system manual Configure the Ethernet Bridging parameters from this menu

Models: 606 624 612 616 604

1 264
Download 264 pages 28.45 Kb
Page 120
Image 120

Section 4 User Interface Guide

Total Access 600 Series System Manual

 

 

BRIDGE > CONFIG > INTERFACES (NETWORK)

Configure the network interface bridging parameters from this menu.

BRIDGE > CONFIG > INTERFACES (NET) > SUB-INTERFACE

The network sub-interface is PPP [0.0] if the L2 PROTOCOL is set for PPP. The [0.0] represents the network physical and logical ports respectively. This is a read-only field. The network sub-interface is FRE [0.X] if the L2 PROTOCOL is set for FRAME RELAY. The [0.X] represents the network physical and logical ports respectively. The network physical port is always 0. The X represents the Frame Relay logical port and will be a number between 0-6 corresponding to the interface number under L2 PROTOCOL > CONFIG > DLCI MAPPING. This is a read-only field.

BRIDGE > CONFIG > INTERFACES (ETH)

Configure the Ethernet Bridging parameters from this menu.

The ETH interface will not appear as a bridge interface entry if the mode is set to route IP.

BRIDGE > CONFIG > INTERFACES (ETH) > SUB-INTERFACE

This is a read-only field which displays the physical and logical port of the interface using the following nomenclature: [A.B], where A represents the physical port (network interface is 0, Ethernet is 1) and B represents the logical port for the Layer 2 protocol (i.e. PVC for Frame Relay, PPP link, etc.) Each configured logical port is assigned a number corresponding to the order in which they are listed in the L2 Protocol configuration fields.

BRIDGE > CONFIG > BRIDGE TABLE

Configure the bridge table parameters from this menu.

BRIDGE > CONFIG > BRIDGE TABLE > BRIDGE TABLE AGING (0-65535)

BRIDGE TABLE AGING is how soon an entry ages out of the Bridge table (in minutes). Default is 5.

BRIDGE > STATUS

View the bridging statistics from this menu.

BRIDGE > STATUS > BRIDGE TABLE

View the bridge table status from this menu.

BRIDGE > STATUS > BRIDGE TABLE > MAC ADDRESS

Ethernet address for device learned. This is a read-only field.

118

© 2004 ADTRAN, Inc.

61200624L1-1B

Page 120
Image 120
ADTRAN 612 Configure the Ethernet Bridging parameters from this menu, Configure the bridge table parameters from this menu