ADTRAN 624, 612, 616, 606, 604 system manual Enter the secret used by RIP version 2 here

Total Access 600 Series System Manual Section 4 User Interface Guide

TX AND RX (DEF)

RIP advertisements are periodically transmitted and are listened to on this port.

TX ONLY

RIP advertisements are periodically transmitted but are not listened to on this port.

RX ONLY

RIP advertisements are listened to on this port, but are not transmitted on this port.

V2 SECRET

Enter the secret used by RIP version 2 here.

PROXY ARP

This feature allows the network portion of a group of addresses to be shared among several physical network segments. The ARP protocol provides a way for devices to create a mapping between physical addresses and logical IP addresses. Proxy ARP makes use of this mapping feature by instructing a router to answer ARP requests as a "proxy" for the IP addresses behind one of its ports. The device which sent the ARP request will then correctly assume that it can reach the requested IP address by sending packets to the physical address that was returned. This technique effectively hides the fact that a network has been (further) subnetted. If this option is set to YES, when an ARP request is received on the Ethernet port the address is looked up in the IP routing table. If the forwarding port is not on the Ethernet port and the route is not the default route, the unit will answer the request with its own hardware address. Default is NO.

SECONDARY IPS

This allows the unit to specify additional IP addresses and networks on its Ethernet. The maximum number of entries is 5.

NUM

Displays the index number in the secondary IP list.

IP ADDRESS

This is the second IP address the unit will respond to on the Ethernet. Default is 0.0.0.0.

SUBNET MASK

This is the mask for the network. Default is 255.255.255.255.

NAT MODE

This mode specifies whether Network Address Translation (NAT) should be used on this interface. When this mode is set to PRIVATE (default) and NAT is enabled for the unit, packets to and from this interface are translated. If set to PUBLIC, packets to and from this interface will not be translated through NAT.

61200624L1-1B © 2004 ADTRAN, Inc. 121