ADTRAN 624, 612, 616, 606, 604 system manual Verifying the Bridge Options, Bridge Options Step Action

Total Access 600 Series System Manual Section 4 User Interface Guide

Layer 2 Protocol Configuration – Ethernet Interface (Continued)

Set mode to BRIDGE ALL. Using this menu you also have the option to route

3only IP packets and bridge all other data packets (ROUTE IP/BRIDGE OTHER) or route all IP data packets on this connection (ROUTE IP). Refer to L2 Protocol (ALL–ETH–802.3) > Config > Mode on page 116 for more details.

4Left arrow back to the main menu to save the changes.

3.Verifying the Bridge Options

For more details on the configuration parameters discussed in this section, refer to the following pages: Bridge menus beginning on page 117

Bridge Options

Step Action

1From the main menu, select BRIDGE and press <ENTER>.

2Use the right arrow key to highlight CONFIG and press <ENTER>.

3Select INTERFACES and press <ENTER>. Verify that the desired interface is listed in this table.

4Left arrow back to the BRIDGE > CONFIG menu.

5Select BRIDGE TABLE and set the BRIDGE TABLE AGING to the desired time (in minutes) it takes an entry to age out of the Bridge table.

6Left arrow back to the main menu to save the changes.

4.Mapping the DS0s

For more details on the configuration parameters discussed in this section, refer to the following pages: DS0 Map menus beginning on page 149

DS0 Mapping Instructions

Step Action

1From the main menu, select DS0 MAPS.

61200624L1-1B © 2004 ADTRAN, Inc. 161