ADTRAN 604, 612, 616 L2 Protocol ATM-NET-CUMTN Config NUM, L2 Protocol ATM-NET-CUMTN Config Active

Section 4 User Interface Guide Total Access 600 Series System Manual

L2 PROTOCOL (ATM–NET–CUMTN) > CONFIG > NUM

Displays the index number in the DLCI config table. The number range is 0-9.

L2 PROTOCOL (ATM–NET–CUMTN) > CONFIG > ACTIVE

When this parameter is set to YES (def), the mapping is used to determine the protocols used. If set to NO, the unit will ignore the virtual circuit with this DLCI.

L2 PROTOCOL (ATM–NET–CUMTN) > CONFIG > INTERFACE

Shows the user the physical and logical port associated with each DLCI. This is a read-only field.

L2 PROTOCOL (ATM–NET–CUMTN) > CONFIG > DLCI

The DLCI (Data Link Connection Identifier) number identifies the virtual circuit being configured. The DLCI range is 16-1023. The default is 16-25corresponding to the index numbers 0-9respectfully.

L2 PROTOCOL (ATM–NET–CUMTN) > CONFIG > CONNECTION

Select the physical and logical method of data transfer over the virtual path. There are two valid connection entries: ROUTER and VOICE. Select ROUTER to connect traffic from this PVC to the Total Access 6XX integral IP router. Select VOICE to connect traffic from this PVC to a voice connection (normally an FXS interface).

L2 PROTOCOL (ATM–NET–CUMTN) > CONFIG > SETUP

This submenu only appears for VOICE connections. Configure the CALL CONTROL for voice gateway using this menu.

L2 PROTOCOL (ATM–NET–CUMTN) > CONFIG > SETUP > CALL CONTROL

The CALL CONTROL setting is used to configure the correct Voice Gateway protocol for voice signaling control between the Total Access 6XX and the configured Gateway. The Call Control setting must be configured correctly before the voice circuits will work correctly. The Total Access 6XX supports

JETSTREAM, COPPERCOM, TOLLBRIDGE and LES-CAS(def).

L2 PROTOCOL (ATM–NET–CUMTN) > STATUS

View the status of the Copper Mountain DLCI connections.

L2 PROTOCOL (ATM–NET–CUMTN) > STATUS > NUM

Displays the index number for the Status menu entries.

L2 PROTOCOL (ATM–NET–CUMTN) > STATUS > SUB-INTERFACE

This is a read-only field which displays the physical and logical port of the interface using the following nomenclature: [A.B], where A represents the physical port (network interface is 0, Ethernet is 1) and B represents the logical port for the Layer 2 protocol (i.e. PVC for Frame Relay, PPP link, etc.) Each configured logical port is assigned a number corresponding to the order in which they are listed in the L2 Protocol configuration fields.

112 © 2004 ADTRAN, Inc. 61200624L1-1B