Total Access 600 Series System Manual

Section 4 User Interface Guide

 

 

SYSTEM UTILITY > TRACEROUTE > TRACE TARGET

Specifies the IP address of the remote system to trace the routes to.

SYSTEM UTILITY > TRACEROUTE > MAXIMUM HOPS

Specifies the maximum number of router exchanges allowed when traveling to the final destination (specified using the TRACE TARGET field) Range is 1 to 30. Default is 30.

SYSTEM UTILITY > TRACEROUTE > TIMEOUT (IN SECS)

Specifies the maximum delay (in seconds) given to a host (along a path to the final destination) to respond to the probe datagram sent before considering the packet a failure.

SYSTEM UTILITY > TRACEROUTE > RETRIES

Specifies the number of times the probe datagram is sent to each host (along the path to the final destination).

SYSTEM UTILITY > TRACEROUTE > BEGIN TRACEROUTE

Activates the traceroute process.

SYSTEM UTILITY > RESET UNIT

Selecting this activator will initiate a soft reset of the unit.

SYSTEM UTILITY > TERMINAL MODE

Selecting the terminal mode gives the user a command-line prompt to perform utilities such as pings, traceroutes, resets, firmware updates, configuration, and more. TERMINAL MODE can also be accessed by using the shortcut keys <Ctrl+T> from other menu screens. From this command-line prompt, you can:

Perform a reset with the command "reset"

Perform a complete factory restore with the command "factory_reset"

Configure the unit. The unit has the ability to download a text file which contains the configuration of the entire unit. This configuration may then be altered in a text editor, and then uploaded to a unit. (See DLP-13,Saving and Loading Text Configuration using Terminal Command Line, for further assistance.)

Debug and troubleshoot. This function would be carried out with the assistance of ADTRAN Technical Support.

Start and stop the fail-safe timer for the auto-config feature.

Perform a firmware upgrade via TFTP.

upgrade_firmware hostname filename

Use the save command to write the entire configuration to flash.

Display the unit’s MAC address with the command mac.

Perform a ping or extended ping. Syntax is:

ping hostname/address [repeat xx] [size xx] [timeout xx] [source xx] [noNat]

61200624L1-1B

© 2004 ADTRAN, Inc.

69

Page 71
Image 71
ADTRAN 616, 612, 606, 624, 604 system manual Activates the traceroute process