ADTRAN 624, 612, 616, 606, 604 Introduction, Tools Required, Unpack and Inspect the System

Network Turnup Procedure Total Access 600 Series System Manual

1.INTRODUCTION

This section discusses Total Access 600 Series installation.

2.TOOLS REQUIRED

The tools required for wallmount installation of the unit are:

•Four #8 x 3/4 inch pan-head wood screws

•Drill and drill bit set

•Flat head screwdriver (medium)

•Two Phillips head screwdrivers (small/medium)

•Wire-wrap gun (optional)

•25-pair male amphenol cable (customer connection)

•Selected punch-down block and tool

To prevent electrical shock, do not install equipment in a wet location or during a lightning storm.

During installation, power should be the last connection made.

Electronic equipment can be damaged by static electrical discharge. Before handling modules, put on an antistatic discharge wrist strap to prevent damage to electronic components. Place equipment in antistatic packing material when transporting or storing. When working on equipment, always place it on an approved antistatic mat that is electrically grounded.

3.UNPACK AND INSPECT THE SYSTEM

Each unit is shipped in its own cardboard shipping carton. Open each carton carefully and avoid deep penetration into the carton with sharp objects.

After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in transit, immediately file a claim with the carrier, and then contact ADTRAN Customer Service (see Customer Service, Product Support Information, and Training in the front of this manual).

36 © 2004 ADTRAN, Inc. 61200624L1-1B