Chapter 7 Controlling Lightweight Access Points
Migrating Access Points from the
Guidelines for Migration
Follow these guidelines before migrating your access points to the
•You can migrate only Cisco Aironet 1130, 1200, and 1240 lightweight access points that support the
•Your controller and all access points must be running software release 4.1 or greater or software release 3.2.193.0.
Note Software release 4.0 is not supported. If you migrate your access points using software release 3.2.193.0, you cannot upgrade to software release 4.0. You can upgrade only to software release 4.1 or later or to a later release of the 3.2 software.
•You must have had one or more Japan country codes (JP, J2, or J3) configured on your controller at the time you last booted your controller.
•You must have at least one access point with a
•You cannot migrate your access points from the
Note You cannot undo an access point migration. Once an access point has been migrated, you cannot return to software release 4.0. Migrated access points will have
Migrating Access Points to the -U Regulatory Domain
Follow these steps to migrate your access points from the
Step 1 To determine which access points in your network are eligible for migration, enter this command:
show ap migrate
Information similar to the following appears:
These 1 APs | are eligible | for migration: |
|
00:14:1c:ed:27:fe | “J”Reg. Domain | ||
No APs have | already been | migrated. |
|
Step 2 Enter these commands to disable the 802.11a and 802.11b/g networks:
config 802.11a disable network
config 802.11b disable network
Step 3 Enter this command to change the country code of the access points to be migrated to J3:
config country J3
Step 4 Wait for any access points that may have rebooted to rejoin the controller.
| Cisco Wireless LAN Controller Configuration Guide |
