Polycom DOC2232A manual Configuring the Network Services, Network Configuration Wizard

Chapter 3 - Initial System Setup

Configuring the Network Services

Initial IP

Configuration

Installing the

MGC Manager

Starting the MGC

Manager

Defining an MCU

Connecting to an MCU

Configuring the

Network Services

If no Network Services have been configured, depending on your system configuration, an appropriate Network Configuration dialog box is automatically displayed.

•If your system is configured to work with both IP and ISDN, the Network Configuration Wizard dialog box is displayed. This section describes the configuration of both IP and ISDN Network Services.

•If your system is configured to work with IP only, the IP Configuration dialog box is displayed. For details, see page 3-10.

•If your system is configured to work with ISDN only, the ISDN Configuration dialog box is displayed. For details, see “To configure an ISDN Network Service:” on page 3-13.

Network Configuration Wizard

The Network Configuration Wizard enables you to set up the ISDN and IP network services quickly.

For information about defining T1-CAS Network Services, defining additional ISDN or IP Network Services, adding advanced definitions or modifying existing Network Services, refer to the MGC Administrator’s Guide, Chapter 3.

You can access the Network Configuration Wizard any time from the MCU right-click menu.

3-9