RoboteQ AX2850 Important Notice about PCM Radios, Transmitter/Receiver Quality Considerations

R/C Operation

If no pulses are present, the motors are disabled, and the controller’s display will scroll alternatively the letters “no ctrl” as shown in Figure 78 below.

FIGURE 78. “No control” message will scroll when no valid radio signal is present

After powering on the R/C radio receiver and transmitter, and if the wiring is correct, the controller will start receiving pulses. For a preset amount of time, the controller will moni- tor the pulse train to make sure that they are regular and therefore genuine R/C radio com- mand pulses. After that, the motors are enabled and the LEDs will display a pattern related to the actual motor direction (see Figure , “Motor Direction Status,” on page 104).

This power-on Watchdog feature prevents the controller from becoming active from para- site pulses and from moving the motors erratically as a result.

Similarly, if the pulse train is lost while the motors were enabled, the controller will wait a short preset amount of time before it disables the motors. If the pulses reappear during that time, the controller continues without any breaks. If the communication is confirmed to be lost, the “no ctrl” message is displayed again.

Note: the Accessory Outputs C will be turned Off when radio is lost.

Important Notice about PCM Radios

PCM radios have their own watchdog circuitry and will output a signal (normally a “safe condition” value) when radio communication is lost. This signal will be inter- preted by the AX2550 as a valid command and the controller will remain active. To benefit from the AX2550’s radio detection function, you will need to disable the PCM radio watchdog.

R/C Transmitter/Receiver Quality Considerations

As discussed earlier in this chapter, the AX2550 will capture the R/C’s command pulses with great accuracy. It will therefore be able to take advantage of the more precise joy- sticks and timings that can be found in higher quality R/C radio, if such added precision is desired in the application.

Another important consideration is the R/C receiver’s ability to operate in an electrically noisy environment: the AX2550 switches high current at very high frequencies. Such tran- sients along long battery and motor wires will generate radio frequency noise that may interfere with the R/C radio signal. The effects may include reduced remote control range and/or induced errors in the command pulse resulting in jerky motor operation.

A higher quality PCM R/C transmitter/radio is recommended for all professional applica- tions, as these are more immune to noise and interference.

While a more noise-immune radio system is always desirable, it is also recommended to layout the wiring, the controller, radio and antenna so that as little as possible electrical

116 AX2550 Motor Controller User’s Manual Version 1.9b. June 1, 2007