Ericsson LBI-39224 manual T1/E1 Interface Card-Equipped PIM Configuration

LBI-39224

Site Channel Configuration List dialog box

Send

Choose the Send button to send the site channel configuration data to the respective interface module. This procedure must be performed before the interface module will operate with the new configuration. Only configured and configured-and-active (C and C/A prefixes) configurations may be sent. All configuration data is sent to the MOM Controller Board; the Audio configuration is sent directly out from there to the respective interface module Controller Board. A "Send to Site Successful" message will be received to confirm that the data was

received by the interface module Controller Board. Bus Slot configuration data is compared to the current configuration at the CEC/IMC Manager; if different, it is sent to the MOM Controller Board (if not, no further action is taken by the system) and when the MOM Controller Board receives this new data it will send an acknowledgment message back to the CEC/IMC Manager, which will then display the confirmation box: "Do you want to activate TDM Bus Slots? OK - will cause all CTRL boards to reset." Choose OK to activate TDM Bus Slots (resetting Controller Boards) with the new Bus Slot configuration data, choose Cancel to not activate TDM Bus Slots with the new Bus Slot configuration data (keeping the previous configuration) and return to the Site Channel Configuration List dialog box.

Close

Choose the Close button to exit the Site Channel Configuration List dialog box and return to the CEC/IMC Manager main window. Any "**" (unconfigured and unsaved) PIMs appearing in the Configured/Active Sites list box will be removed and returned to the Configurable Sites list box.

T1/E1 Interface Card-Equipped PIM Configuration

This section describes configuration for channels of T1/E1 Interface Card-equipped PIMs (currently only MIMs, NIMs, and PIMs are so

equipped). Channel configurations are performed from the T1/E1 Digital Site Configuration dialog box (see Figure 18 on page 3-

39)and from the T1/E1 Interface Card Auto-configurationdialog box (see Figure 19 on page 3-42). As was the case with Audio Board- equipped site-type interface modules, only those "sites" which were selected in the Site Channel Configuration List dialog box are available for channel configuration.

3-72