Ericsson LBI-39224 Tone Control/DC Control Configuration State Tables, Etc, Command Definition

LBI-39224

Close
Choose	the	Close	button	to	exit	the

Conventional Channel Configuration dialog box and return to the CEC/IMC Manager main window. Any configuration changes not saved will be lost; there is no prompt to save any changes before exiting.

Tone Control/DC Control Configuration ("State Tables," Etc.)

Conventional channel Tone Control/DC Control (low-level) configurations primarily involve "state table" configurations used to

specify tone and DC-controlled signaling requirements. Each conventional channel has a corresponding state table. In many cases, state table changes are not necessary since default values match standard conventional base station remote control signaling requirements.

The following commands are supported on both tone and DC configurations.

Table 8 Conventional Base Station Commands

COMMAND	DEFINITION
SET TX FREQ 1	Set to transmit on frequency 1.
SET TX FREQ 2	Set to transmit on frequency 2.
SET TX FREQ 3	Set to transmit on frequency 3.
SET TX FREQ 4	Set to transmit on frequency 4.
SET TX FREQ 5	Set to transmit on frequency 5.
SET TX FREQ 6	Set to transmit on frequency 6.
SET TX FREQ 7	Set to transmit on frequency 7.
SET TX FREQ 8	Set to transmit on frequency 8.
SET RX FREQ 1	Set receive frequency to frequency 1.
SET RX FREQ 2	Set receive frequency to frequency 2.
SET RX FREQ 3	Set receive frequency to frequency 3.
SET RX FREQ 4	Set receive frequency to frequency 4.
SET RX FREQ 5	Set receive frequency to frequency 5.
SET RX FREQ 6	Set receive frequency to frequency 6.

3-166