Ericsson LBI-39224 manual Unit Timed Logout Configuration, Configure Unit Timed Logout, 192

LBI-39224

–Unit Timers set to No Timeout never log off. This is used for units that show very little activity.

–Unit Timers decrement each minute but reset when a unit shows activity.

–ACTIVITY is defined as a PTT or radio login.

–ALL unit timers can be suspended from decrementing by unselecting (disable) "Multisite Unit Logout" in the

System Options dialog box (Configure System / System Options / Multisite Settings). This does not reset unit timers or change unit timer reset values, so if "Multisite Unit Logout" is selected (enable) the unit timers will again decrement from the previously set values.

Command Logout

Command logout instantly logs the requested unit off of all sites. The command logout option can be selected to mark and logoff operator selected units when it is not desired to have units automatically log off the CEC/IMC (timed logout).

3.20.1 Unit Timed Logout Configuration

Unit logout timers are set at the CEC/IMC Manager from the Unit/Group Location and Unit Logout dialog box. With the timer- based multisite unit logout option, each unit has a count-down timer in the MOM that is initialized at radio login and re-initialized at each radio PTT. The MOM periodically decrements each timer and when the timer for a particular unit times-out the CEC/IMC will either logout the unit, or query the unit if "Multisite Logout Polling" is enabled, and if there is no response to this query logout the unit. Each unit's timer can be programmed in 15-minute increments up to 24 hours. Typically, most timers will be set in the 8- to 10-hour range. Set the timers to the required amount.

Configure Unit Timed Logout.

The operator can select any unit for unit timer configuration from the list box displaying Unit Alias, LID, and Timeout value. The unit alias, LID, group alias, and GID will also be displayed in the Manual Entry fields (see below). The number of units available for selection is displayed at the lower right corner of the list box (# Units Displayed). The time-out value that is displayed for the units is the MOM Controller Board NOVRAM stored time. Select the time-out value from the Select Timeout drop-down list box, the selection choices are

3-192