Ericsson LBI-39224 manual State Table, 165

LBI-39224

reprograms the CCI and VMIM Controller Boards. If after making changes, a save is performed but a send is not, the actual CEC/IMC conventional channel operation will differ from the displayed settings upon re-entering the Conventional Channel Configuration dialog box.

Save

Choose the Save button to save the currently selected local conventional channel's configuration to the CEC/IMC Manager's hard disk drive. If during the current edit session, any other channels' configurations have changed, these channels are not saved. A remote conventional channel's configuration cannot be saved. All of the channel's high-level and low-level configurations are saved at the CEC/IMC Manager.

Send

Choose the Send button to send the currently selected conventional channel's high-level and low-level configuration to the CEC/IMC. A Send also automatically saves the currently selected channel's configuration to the CEC/IMC Manager. Configuration data is distributed to the channel's VMIM/CIA set as required. All settings affect (are programmed/stored within) the CCI Controller Board and the CI Boards within the respective CIA rack. In addition, Causeway settings also affect the respective VMIM Controller Board.

State Table
Choose the State Table button to	display	either	the
Tone Controlled Station State Table Mapping dialog		box or	the
DC Controlled Station State Table Mapping	dialog	box.	The

control signaling type selected earlier (above) determines which dialog box will be displayed when State Table is chosen. Tone Control/DC Control configuration on the currently selected conventional channel is provided by these dialog boxes. If any changes have been made and not saved, you will be prompted (Write Changes to Disk?) to save and display one of the above state table dialog boxes (Yes), display one of the above state table dialog boxes without saving (No), or cancel the

State Table command (Cancel) and remain in the

Conventional Channel Configuration dialog box. See Tone Control/DC Control Configuration ("State Tables," Etc.) on page 3-166 for additional details.

3-165