Ericsson LBI-39224 manual Device Conflict

LBI-39224
LOGGED	LOGGED						CAUSE/
ERROR		ERROR			CORRECTIVE
MESSAGE		DATA					ACTION
E08-18:	No information in the				A Controller			Board	device
DEVICE CONFLICT -	data word.				type/assignment			setting	is
CONTROL BOARD					conflicting		with	another	board's
					setting. For example a VMIM 5
					and a MIM 5 will conflict with
					each other. The main information
					is the device type/assignment in the
					error heading. With the correct
					hardware revision, the ID LED will
					also be flashing on the offending
					board. Also, sometimes this error
					only applies to one board.
					(Example CCI, or second MOM
					mistakenly		installed in		main
					CEC/IMC		rack).	Corrective
					Action: The offending board must
					be removed and its type/assignment
					setting must be changed to not
					conflict with another device. The
					other device should also be
					displaying this error and it should
					also be reset.
E09-139:	Data	field	is	the	The T1/E1 Interface Card has lost
T1/E1 INTERFACE -	T1/E1 Interface Card				its T1/E1 signal.
LOSS OF SIGNAL	affected (1-8).
E09-140:	Data	field	is	the	A valid T1/E1 receive framing
T1/E1 INTERFACE -	T1/E1 Interface Card				sequence no longer exists at the
LOSS OF FRAME	affected (1-8).				T1/E1	Interface		Card.	Two
SYNC					possible causes would be that the
					frame format changed at one end of
					the T1/E1 link or loss of the T1/E1
					signal.
E09-141:	Data	field	is	the	A Frame Slip occurs when a
T1/E1 INTERFACE -	T1/E1 Interface Card				clocking	frequency mismatch (at
EXCESSIVE FRAME	affected (1-8).				the card level) causes received
SLIPS					frames to be repeated or discarded.
					Excessive frame slips indicate a
					clock failure on the T1/E1 Interface
					Card.

A-6