Ericsson LBI-39224 manual Save And Send MIM T1/E1 Configurations

LBI-39224

←⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯ DS0 ⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯→

subchannel 1	subchannel 2	subchannel 3	subchannel 4	subchannel 5
1	2	3	4	5
	6	7	8

Table 3 Synchronous Subrate Port Packing Arrangement

Save And Send MIM T1/E1 Configurations

Any	T1/E1 Digital Site Configuration	dialog	box	or
T1/E1 Interface Card Auto-configuration		dialog box	changes	must

be sent before the changes will come into effect at the CEC/IMC. This reprograms the MIM Controller Boards and T1/E1 Interface Cards. The new configurations must be saved before sent to the CEC/IMC, if sending is attempted before saving a "Site data must be saved to disk prior to send" message box will appear. Save and send may be performed either from the T1/E1 Interface Card Auto-configurationdialog box only, or from the Site Channel Configuration List dialog box, similar to Audio Board save and send.

T1/E1 Interface Card Auto-configuration dialog box

Save

Choose the Save button to perform an immediate save of the currently selected site-type interface module's channel configuration. The channel configuration is saved on the CEC/IMC Manager's hard disk drive. Any previous channel configuration for the "site," if present, is erased and replaced with the current channel configuration. If the CEC/IMC Manager is running remotely or as a part of the EDACS Network Manager, this configuration is saved on the CEC/IMC Manager server, typically local to the CEC/IMC; it is not saved at the remote location.

Send

Choose the Send button to send the T1/E1 site channel configuration data to the respective interface module. This procedure must be performed before the interface module will operate with the new configuration. Only configured and configured-and-active (C and C/A prefixes) configurations may be sent. All configuration data is sent to the MOM Controller Board; the T1/E1 configuration is sent directly out from there to the respective interface module Controller Board. A

3-44