Ericsson LBI-39224 manual Input Event, Deactivate buttons, Console Tone Alarm, Input Message, 182

LBI-39224

for details on the wiring of the I/O ports/bits. Select the event type (Input or Output) from the Event Type drop-down list box.

Input Event

If Input is selected several other fields are affected and require configuration as described in the following paragraphs.

–The Console Tone Alarm drop-down list box will be displayed below the Event Type field, replacing the Activate and

Deactivate buttons.

–The Input Message text box will be displayed in the lower right quadrant of the dialog box, replacing the Activate and Deactivate fields.

–The Message Window Text text box will be displayed in the lower left quadrant of the dialog box, replacing the Activate Function and Output Deactivate fields (all fields in this quadrant are currently not used, they are for future console development).

Console Tone Alarm

Use this field to specify if an alarm tone will be heard at the consoles for the event currently being configured. Select either Alarm Off or Alarm On from the drop-down list box.

Input Message

NOTE

The Input Message for C3 Modular/Desktop consoles must be

UPPER CASE alphanumeric characters. There is no restriction for any other console type.

This field displays the input event's defined text message (8 characters max). This message is sent to any console that has been selected in the Console Mask field when the input becomes active. On the C3 Maestro console, the message will be displayed in the bottom left corner of the CRT. On the C3 Modular/Desktop console, the message is displayed in the 8-character alphanumeric LED display (see NOTE). Because these display positions are used for other messages, the I/O event message is displayed for approximately five (5) seconds and then cleared. Select Log Event State Changes for a more permanent record of the input event occurrence.

3-182