Ericsson LBI-39224 manual Link Fail

LBI-39224
LOGGED	LOGGED						CAUSE/
ERROR		ERROR					CORRECTIVE
MESSAGE		DATA					ACTION
						Control data link failure between
E03-028:	0000h = CIM control
LINK FAIL -	data		link	failure.		CIM and console.
CONSOLE	0001h		=	Attached
	console		is	"Logged
	Out"	or "Disabled."
	For	a	C3	Desktop/
	Modular			console,
	0001h		indicates		the
	Translator-to-console
	control		data	link	has
	failed.
E03-029:						Control data link failure between
LINK FAIL -						LRIM and logging recorder.
RECORDER (Reserved
for future use.)
E03-030:						Control data link failure between
LINK FAIL - RSM						RIM and RSM equipment.
MONITOR
E03-031:						Control data link failure between
LINK FAIL - CTIS						PIM/CTIM and		Jessica/CTIS
						equipment.
E03-035:	No	information			is	The idle flag sequence cannot be
LINK FAIL - HDLC	contained in the data					detected on HDLC channel A.
CHANNEL A	word.					Corrective Action:		To clear the
						error, proper connection to HDLC
						channel A, via the backplane
						connector, must be made to a
						remote	station that	continuously
						transmits idle flag sequences at the
						correct bit rate.
E03-036:	Lower		byte	of	the	An Audio Board at a secondary
LINK FAIL - HDLC	data	word		contains		address on HDLC channel B that
CHANNEL B	01h,		indicating			was previously responding to polls
	channel B. The upper					has	stopped	responding.
	byte of the data word					Corrective Action:		To clear the
	contains the			number		error, an Audio Board set to the
	of the		Audio Board			same number that caused the error
	that			stopped		must be placed in the system, or
	responding.					the	Controller	Board that
						originated the error must be reset.

A-4