Ericsson LBI-39224 manual Save and Send DC Control Configurations, 173

LBI-39224

CG ENABLE	-6	-6	0	0	–	+6	+11
CG DISABLE	-11	-11	-2.5	-2.5	–	+6	+11

The columns beneath the DC Control Current heading represent the next state the station must go to implement a new command; for example, if the station is presently at the -11 mA state and receives a DC control current of -2.5 mA, the station will know that this is a command to "SET RX FREQ 1 WITH CG ENABLED" based on its configuration (the station will then be at the -2.5 mA state). The DC channel programming also specifies that a non-transmit state is not allowed if the station is in a transmit state (a transmit command will not be pre-empted by a non-transmit command).

Save and Send DC Control Configurations

When programming is complete for a channel, the new configurations must be sent to the CI Board before they will take effect. The new configurations will also be saved to the CEC/IMC Manager hard disk when sent to the CEC/IMC.

Save

Choose the Save button to save the currently selected local conventional channel's configuration to the CEC/IMC Manager's hard disk drive. A remote conventional channel's configuration cannot be saved. All of the channel's DC Control configuration is saved at the CEC/IMC Manager.

Send

Choose the Send button to send the currently selected conventional channel's low-level configuration to the CEC/IMC. Configuration data is distributed to the channel's VMIM/CIA set as required. All settings effect (are programmed/stored within) the CCI Controller Board and the CI Boards within the respective CIA rack. A Send will also automatically save the configuration at the CEC/IMC Manager.

Close
		Close
Choose	the				button			to	exit
DC Controlled Station State Table Mapping						dialog		box	to the
Conventional Channel Configuration dialog						box.	If	any changes
have been	made	and	not	saved,	you	will	be		prompted
(Write Changes to Disk?)			to	save exit	(Yes), exit		without saving

3-173