Ericsson LBI-39224 manual Remote Control, Standby Site, Control Signaling, Tone, 162

LBI-39224

Remote Control

Select this option if the currently selected conventional channel is connected through a Conventional Concentrator Card and the card is wired in remote controller enable/disable configuration and consoles should be allowed to toggle the relays by sending remote enable/disable commands (for example, F1 function key from the C3 Maestro console's conventional function note card). When remote control is enabled, remote controllers are paralleled with the CEC/IMC. When disabled, assuming recommended wiring for this card configuration, remote controllers are disconnected from the stations.

Standby Site

Select this option if the currently selected conventional channel is connected via a Conventional Concentrator Card and the card is wired in main/standby station configuration and consoles should be allowed to toggle the relays by sending main/standby commands (for example, F6 function key from C3 Maestro console's conventional function note card). When the relays are toggled to the standby position, assuming recommended wiring for this card configuration, standby (back-up) conventional base stations are connected and main (primary) stations are disconnected.

Control Signaling

The CEC/IMC can be interfaced to tone and/or DC remote controlled conventional base stations with or without E&M

signaling. Each CEC/IMC conventional channel must be configured accordingly. Remote control signaling selection is provided by this group of option buttons. For the currently selected channel, select the required option by selecting the respective option button. If modifications to standard tone/DC control signaling are required, refer to the low-level configuration information in Tone Control/DC Control Configuration ("State Tables," Etc.) on page 3-166. Control Signaling default = "Tone."

Tone

Standard tone signaling on all commands, no E&M M-lead signaling. Standard tone signaling can be modified per State Table (low-level) configuration on a per command basis.

3-162