Ericsson LBI-39224 manual Save As… Dialog Box, Site Channel Configuration List dialog box Send

LBI-39224

Figure 17 "Save As…" Dialog Box

For example, if "Site 8" is the currently selected site-type interface module and "Site 12" requires similar configuration settings, this button may be used to save the "Site 8" configuration as "Site 12" (save to "12"). The new "site" may then be changed later, as required, by selecting it from the selection list box, changing the configuration as required, and then choosing Save.

Close

Choose the Close button to exit the Site Channel Configuration dialog box and enter the Site Channel Configuration List dialog box. If any changes have been made and not saved, you will be prompted (Write Changes to Disk?) to save and exit (Yes), exit without saving (No), or cancel the Close command and remain in the dialog box (Cancel).

Site Channel Configuration List dialog box

Send

Choose the Send button to send the site channel configuration data to the respective interface module. This procedure must be performed before the interface module will operate with the new configuration. Only configured and configured-and-active (C and C/A prefixes) configurations may be sent. All configuration data is sent to the MOM Controller Board; the Audio configuration is sent directly out from there to the respective interface module Controller Board. A "Send to Site Successful" message will be received to confirm that the data was

received by the interface module Controller Board. Bus Slot configuration data is compared to the current configuration at the CEC/IMC Manager; if different, it is sent to the MOM Controller Board (if not, no further action is taken by the system) and when the

3-34