Ericsson LBI-39224 manual Dvim Configuration, 135

LBI-39224

Configured/Active Sites Prefix Definitions, on page 3-25 for an explanation of the different prefixes if necessary.

Add

Choose the Add button to move a selected DVIM from the Configurable DVIM list box and "add" it to the Configured/Active DVIM list box where it can be configured. If upon adding a DVIM, a configuration data file exists on the CEC/IMC Manager's hard disk drive from a previous add and delete, the DVIM will be added with a "C" prefix. This previous configuration may be modified, saved and sent as needed.

Delete

Choose the Delete button to remove ("delete") a selected configured or unconfigured DVIM from the Configured/Active DVIM list box to the Configurable DVIM list box. Configured-and-active DVIMs cannot be "deleted." This delete function does not remove DVIM channel configuration files from the CEC/IMC Manager's hard disk drive. If the deleted DVIM is subsequently added back to the Configured/Active DVIM list box using the Add button, the previous channel configuration is not lost.

CAUTION

Channels with a dedicated group will not be undedicated in the Delete process. Channels should be undedicated (See Dedicated Channels below) before a DVIM is deleted. Failure to undedicate these channels before deleting the DVIM may cause erratic behavior of the CEC/IMC.

Modify
Choose	the	Modify	button	to	display	the

DVIM Channel Configuration dialog box, which is where channel configuration actually is performed. One or more "sites" must be selected in the Configured/Active Sites list before the DVIM Channel Configuration dialog box will be displayed.

3.12.2 DVIM Configuration

This section describes configurations for channels within DVIMs. The fundamental DVIM channel parameters are permanently set and cannot

3-135