Ericsson LBI-39224 manual T1/E1 Digital Site Configuration dialog box Save

LBI-39224

action is taken by the system) and when the MOM Controller Board receives this new data it will send an acknowledgment message back to the CEC/IMC Manager, which will then display the confirmation box: "Do you want to activate TDM Bus Slots? OK - will cause all CTRL boards to reset." Choose OK to activate TDM Bus Slots (resetting Controller Boards) with the new Bus Slot configuration data, choose Cancel to not activate TDM Bus Slots with the new Bus Slot configuration data (keeping the previous configuration) and return to the T1/E1 Interface Card Auto-configurationdialog box.

T1/E1 Digital Site Configuration dialog box

Save

Choose the Save button to perform an immediate save of the currently selected site-type interface module's channel configuration. This channel configuration is saved on the CEC/IMC Manager's hard disk drive. Any previous channel configuration for the "site," if present, is erased and replaced with the current channel configuration. If the CEC/IMC Manager is running remotely or as a part of the EDACS Network Manager, this configuration is saved on the CEC/IMC Manager server, typically local to the CEC/IMC; it is not saved at the remote location.

Save As...

Choose the Save As… button to allow the currently selected site-type interface module channel configurations to be saved as a different site- type interface module. It is provided to speed configurations when similar PIM configurations are required. Upon choosing Save As… a small dialog box, similar to Figure 17 on page 3-34, will appear which allows selection of a new PIM number. Select the desired PIM number from one of the choices in the displayed list, the choices displayed are the selected PIMs in the Configured/Active Sites list box. Like Save, Save As… stores channel configuration on the CEC/IMC Manager server.

Close

Choose the Close button to exit the T1/E1 Digital Site Configuration dialog box. If any changes have been made and not saved, a prompt will appear to warn of the unsaved changes and the user will be given the opportunity to save and exit (Save)or exit without saving the changes (Cancel).

3-81