Ericsson LBI-39224 manual Close

LBI-39224

choosing Save As… a small dialog box (see Figure 17 on page 3-34) will appear which allows selection of a new VMIM number. Select the desired VMIM from one of the choices in the drop-down list box, the choices listed are the selected VMIMs in the Configured/Active Sites list box. Like Save, Save As… stores channel configuration on the CEC/IMC Manager server.

Close

Choose the Close button to exit the Site Channel Configuration dialog box and return to the Site Channel Configuration List dialog box. If any changes have been made and not saved, you will be prompted (Write Changes to Disk?) to save and exit (Yes), exit without saving (No), or cancel the Close command and remain in the dialog box (Cancel).

Site Channel Configuration List dialog box

Send

Choose the Send button to send the site channel configuration data to the respective interface module. This procedure must be performed before the interface module will operate with the new configuration. Only configured and configured-and-active (C and C/A prefixes) configurations may be sent. All configuration data is sent to the MOM Controller Board; the Audio configuration is sent directly out from there to the respective interface module Controller Board. A "Send to Site Successful" message will be received to confirm that the data was

received by the interface module Controller Board. Bus Slot configuration data is compared to the current configuration at the CEC/IMC Manager; if different, it is sent to the MOM Controller Board (if not, no further action is taken by the system) and when the MOM Controller Board receives this new data it will send an acknowledgment message back to the CEC/IMC Manager, which will then display the confirmation box: "Do you want to activate TDM Bus Slots? OK - will cause all CTRL boards to reset." Choose OK to activate TDM Bus Slots (resetting Controller Boards) with the new Bus Slot configuration data, choose Cancel to not activate TDM Bus Slots with the new Bus Slot configuration data (keeping the previous configuration) and return to the Site Channel Configuration List dialog box.

Close

Choose the Close button to exit the Site Channel Configuration List dialog box and return to the CEC/IMC Manager main window. Any

3-90