Ericsson LBI-39224 manual Add

LBI-39224

Configured/Active Sites:

The Configured/Active Sites list box displays NIMs which have been added but not yet channel-configured, NIMs which have had previous channel configurations performed, and NIMs which have been previously channel-configured and have an active Controller Board control data link. Before a site-type interface module can be channel- configured, it must be listed in the Configured/Active Sites list box. Any number of the available NIMs may be selected at one time for modification in the Site Channel Configuration dialog box. All selected NIMs in this list will also be included in the "Save As… " dialog box that is accessed from the Site Channel Configuration dialog box or the T1/E1 Digital Site Configuration dialog box. See Table 1 for Configured/Active Sites Prefix Definitions on page 3-25 if necessary.

Add

Choose the Add button to move a selected NIM from the Configurable Sites list box and "add" it to the Configured/Active Sites list box where it can be selected for configuration. If upon adding a NIM, a configuration data file exists on the CEC/IMC Manager's hard disk drive from a previous add and delete, the NIM will be added to the Configured/Active Sites list box with its configuration data file (with a

**prefix). This previous configuration may be modified, saved, and sent as needed.

Delete

Choose the Delete button to remove ("delete") a selected configured or unconfigured NIM from the Configured/Active Sites list box to the Configurable Sites list box. Configured-and-active NIMs cannot be "deleted." This delete function does not remove NIM channel configuration files from the CEC/IMC Manager's hard disk drive. Therefore, if the deleted NIM is subsequently added back to the Configured/Active Sites list box using the Add button, the previous channel configuration is not lost (this configuration data must be re- saved in the Site Channel Configuration dialog box before it can be resent to the CEC/IMC).

Modify

Choose the Modify button and the Audio Interface Type dialog box will be presented, select either Audio Board or T1/E1 Interface as required by clicking the appropriate option button. Selecting Audio Board will activate the Site Channel Configuration dialog box,

3-49