Nortel Networks 1000BASE-SX manual Requirements, Parameters not saved to the configuration file

172Chapter 3 Using the console interface

Requirements

The following requirements apply to the Configuration File feature:

•The Configuration File feature can only be used to copy standalone switch configuration parameters to other standalone switches or to copy stack configuration parameters to other stack configurations.

For example, you cannot duplicate the configuration parameters of a unit in a stack configuration and use it to configure a standalone switch.

•A configuration file obtained from a standalone switch can only be used to configure other standalone switches that have the same firmware revision and model type as the donor standalone switch.

•A configuration file obtained from a stack unit can only be used to configure other stacks that have the same number of switches, firmware version, model types, and physical IDs as the stack the donor stack unit resides in.

Reconfigured stacks are configured according to the unit order number of the donor unit. For example, the configuration file parameters from a donor unit with physical ID x are used to reconfigure the unit with physical ID x.

Table 41 describes configuration file parameter information.

Table 41 Parameters not saved to the configuration file

These parameters are not saved:	Used in this screen:	See page:
In-Band Stack IP Address	IP Configuration/Setup	94
In-Band Switch IP Address
In-Band Subnet Mask
Default Gateway
Console Read-Only Switch Password	Console/Comm Port Configuration	147
Console Read-Write Switch Password
Console Read-Only Stack Password
Console Read-Write Stack Password
Configuration Image Filename	Configuration File Download/Upload	169
TFTP Server IP Address

209418-A