Nortel Networks 1000BASE-ZX, 1000BASE-SX, 1000ASE-XD manual IP Configuration/Setup screen fields

			Chapter 3 Using the console interface 95
Table 10 IP Configuration/Setup screen fields
Field	Description
BootP Request	One of four modes of operation for BootP. (See “Choosing a BootP request mode” on
Mode	page 96 for details about the four modes.)
	Default Value		BootP Disabled
	Range		BootP Disabled, BootP When Needed, BootP Always, BootP or Last
			Address
Configurable	Column header for the user-configurable IP configuration fields in this screen.
In Use	Column header for the read-only fields in this screen. The read-only data displayed in
	this column represents IP configuration that is currently in use.
Last BootP	Column header for the read-only fields in this screen. The read-only data displayed in
	this column represents IP configuration obtained from the last BootP reply received.
In-Band Stack IP	The in-band stack IP address field. This field is not required for the operation of the
Address	standalone switch.
	Default Value		0.0.0.0 (no IP address assigned)
	Range		Four-octet dotted-decimal notation, where each octet is represented
			as a decimal value, between 0 and 255, separated by a decimal
			point
In-Band Switch	The in-band IP address of the switch. This field is not required for the operation of the
IP Address	stack. This field can not use the same IP address used for the stack.
	Default Value		0.0.0.0 (no IP address assigned)
	Range		Four-octet dotted-decimal notation, where each octet is represented
			as a decimal value, between 0 and 255, separated by a decimal
			point
		Note: When the IP address is entered in the In-Band IP Address field, and the
		In-Band Subnet Mask field value is not present, the software provides an in-use
		default value for the In-Band Subnet Mask field that is based on the class of the
		IP address entered in the In-Band IP Address field.

Using the BayStack 420 10/100/1000 Switch