NETGEAR GS728TPP, GS752TP manual Mac Acl

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches

ACL Based on	Fields
Source IPv4 L4 Port	• Source L4 port (protocol). Specify the source IPv4 L4 port protocol.
	• Source L4	port (value). Specify the source IPv4 L4 port value.
Destination IPv6 L4	• Destination L4 port (protocol). Specify the destination IPv6 L4 port protocol.
Port	• Destination L4 port (value). Specify the destination IPv6 L4 port value.
Source IPv6 L4 Port	• Source L4	port (protocol). Specify the source IPv6 L4 port protocol.
	• Source L4	port (value). Specify the source IPv6 L4 port value.

4.In the Binding Configuration area, the Inbound only packet filtering direction for an ACL is selected in the Direction field.

5.In the Port Selection Table area, specify the list of all available valid interfaces for ACL mapping.

All non-routing physical interfaces and interfaces participating in the LAG are listed.

6.To add a rule to the ACL, select the check box next to the ACL, then click ADD.

7.Click APPLY to update the switch with the new settings. Configuration changes take effect immediately.

MAC ACL

A MAC ACL consists of a set of rules that are matched sequentially against a packet. When a packet meets the match criteria of a rule, the specified rule action (permit or deny) is taken and the additional rules are not checked for a match.

The steps for defining a MAC ACL and applying it to the switch are described in the following sections:

1.Use the MAC ACL screen to create the ACL ID.

2.Use the MAC Rules screen to create rules for the ACL.

3.Use the MAC Binding Configuration screen to assign the ACL by its ID number to a port.

4.Optionally, use the MAC Binding Table screen to view the configurations.

190